This is where you’ll place the Welcome vinyl later, or anything else you want to customize it with. Next, you’ll add the 1×6 plate onto the front of the stand. Add some glue to the hook’s threads, and then screw it into the hole. Drill a little hole in the underside of the top 2×4. Since this is going to be a hanging basket plant stand, you will of course want to add a hook to hang the basket from. So now you should have your basic frame of 2x4s, with a 2×6 screwed onto each end for the top and bottom of the stand. Next, do the same thing for the bottom of the stand, but instead of drilling from the inside, you’ll want to make the screw holes on the outside of the frame (Going through the 2×6 into the 2×4), so that those two screws won’t be visible when it’s standing on the ground. This will actually be the top of the welcome plant stand, so go ahead and drill two holes here, and screw the pieces together from the inside (going through the 2×4 into the 2×6). Take one of the 2圆s, lay it flat, and put some glue down the middle. Now that you have your basic frame, the next step is to add the top and bottom pieces, which will cover up those screws. Repeat this process for each corner of the frame. Again, make sure everything is lined up when you drill the holes and when you drive the screws in so that your rectangular frame is straight. Switch out the drill bit for a screw, and drive the screws into the holes you made. Make sure the pieces of wood are lined up correctly, and then, with your drill bit, drill two holes straight through the top 2×4 and into the end of the side 2×4. Start by drilling holes where the screws will go. Next we’re going to screw the top and bottom pieces of wood to the sides. The shorter ones will be the top and bottom of the plant stand, and the longer ones will be the sides. Once the paint is dry, it’s time to put the frame together. I love it because of how smooth it goes on, and how pigmented it is. I’m using Manta Ray by Sea Paint, which is their shade of black. Then paint each side, and don’t forget the ends. Make sure to get rid of any splinters or rough edges. Once it’s cut, use a sander to smooth and clean up the ends and corners. The first thing you’ll need to do is measure out and cut your wood. Related: Which Cricut is the best to buy for beginners? How to Build DIY Hanging Plant Stand I used the color Silver for this project. The best permanent vinyl to get is Oracle 651. If you use vinyl on your plant stand, be sure to use PERMANENT vinyl as your stand will be outside. They do offer pieces of wood in shorter lengths for dirt cheap. I had the 1×6 in my scrap pile, but if you don’t have a scrap pile be sure to check the scrap section at the store. I purchased two 2x4s that were 6 feet long and one 2×6 that was 6 feet long. I bought the wood at Lowes, you’ll be able to find it at any home improvement store. Free Welcome SVG file (Details on how to get my free SVG at the bottom of this post). ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |